Swim'n Play 4ft Manuel d'utilisateur télécharger pdf (Page 10)

Remove wall from carton.

NOTE: the UP arrow on

wall.

Determine starting point

as the filter inlet and

outlet holes are at the

beginning of the wall.

Starting at the center of a

bottom plate insert the bottom edge of the wall into

the groove on the bottom rail. Ensure that the center line of the closure holes in the the wall align with the

center of the plate. Make sure that the cutouts for filter inlet and outlet are on the top portion of the wall and

will not be hidden behind a vertical. If the wall ends do not meet, adjust the bottom rail in or out of the bottom

plates. The spacing in all bottom plates should be equal.

BOTTOM RAIL AND STRAP LAYOUT

Follow the instructions below to properly layout the rail and strap assemblies.

EXAMPLE

OF BASIC

LAYOUT

Patio Block

Bottom Plate

Strap Assembly

45½”

Bottom Rails

Long

Bottom Rail

45½” Bottom Rail

Ground Shield

(Optional)

Transition

Rails

Transition Rails

Transition

Rails

BOTTOM

RAIL

BOTTOM PLATE

PATIO BLOCK

1/16”

PRE WASHED SAND OR

SIFTED EARTH RECOMMENDED

REQUIREMENT CHART

POOL SIZE TONS YARDS

18’ x 12’ 2.4 Tons 1.6 Cu.

24’ x 12’ 3.3 Tons 2.2 Cu.

24’ x 15’ 3.8 Tons 2.5 Cu.

30’ x 15’ 4.8 Tons 3.2 Cu.

33’ x 18’ 6.0 Tons 4.0 Cu.

39’ x 18’ 7.2 Tons 4.8 Cu.

45’ x 18’ 8.3 Tons 5.5 Cu.

Mark out pool radius (1/2 pool width) using stakes

"B" as a reference. Form the two end semicircles by

sliding the long bottom rail groove up, into the bottom

plates. Lay out the strap assemblies as shown

removing the stakes as you go. The distance from strap

to strap is 48". Install the 45½” bottom rail in between

each strap as shown. All rails are curved, including the

45½” used on the straight side.

Bring the required amount of sifted earth or pre-

washed sand into the pool area at this time. Refer to

chart on the right for the required minimum amount.

Place patio blocks under all bottom plates and end of

strap assemblies.

GROUND SHIELD

AND WALL GUARD

ARE OPTIONAL

Spread a ground shield or plastic

sheeting over prepared ground

(not included). Ground Shield and

Wall Guard are available from your

local pool supply dealer or polyeth-

ylene sheeting can be purchased

from a local hardware supply. This

will protect your pool liner and

metal parts against chemical

reactions from the ground soil.

QUANTITIES NEEDED:

POOL SIZE 18x12 24x12 24x15 30x15 33x18 39x18 45x18

STRAP ASSEMBLIES 2334 467

45½” RAILS 2 4 4 6 6 10 12

LONG RAILS 8888101010

TRANSITION RAILS 4444 444

BOTTOM PLATES 10 10 10 10 12 12 12

48”

INSERT WALL INTO BOTTOM RAILS

SKIMMER INLET

4’ x 4’ Plywood

SKIMMER OUTLET

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Swim'n Play 4ft Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Piscines hors sol Swim'n Play 4ft