Swim'n Play ABOVE GROUND SWIMMING POOL Manuel d'utilisateur télécharger pdf (Page 23)

7" AND 9” TWO-PIECE WRAP AROUND COVER

AND PEDESTAL

Slide the inside cover (the cover which will be closest to the inside of the pool) into position

and align the hole in the cover with the cage nut attached to the top plate. Secure using the

1/4”-20 x 3/4” screw provided. Slide the outside cover onto the inside cover. Make sure the inside

cover is in the slot of the outside cover. Align the holes on the side of the bottom wrap with the

holes on the top of the vertical. Secure the cover using the #12 x 1/2” screws provided. The two

(2) edges of the covers should be parallel. Before tightening the screws, press the two covers

firmly together.

WRAP AROUND

PEDESTAL

Place the pedestal onto the

bottom of the vertical and align the

holes on the side of the wrap with

the holes on the bottom of the

vertical. Secure the pedestal using

the #12 x 1/2” screws provided.

INSIDE COVER

1/4”-20 X 3/4”

STAINLESS STEEL SCREW

#12X1/2” SCREW

1 ON EACH SIDE

#12X1/2” SCREW

1 ON EACH SIDE

If your pool vertical does not have holes, simply use

the cover or the pedestal as a template and drill through

the vertical using a 9/64" diameter drill bit, being careful

not to damage the pool wall.

9” WRAP

AROUND

COVER

7” WRAP

AROUND

COVER

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Swim'n Play ABOVE GROUND SWIMMING POOL Manuel d'utilisateur Page 23