ASSEMBLY INSTRUCTIONS 12 ft. 15 ft. 18 ft.ENDDECKSPart # 420867READ THROUGH AND UNDERSTAND ALL THE STEPS TO THIS INSTALLATION BEFORE ATTEMPTING TO IN
1018’ END DECK15’ END DECK12’ END DECKLADDER6For the 12’ End Deck attach the two 75” Bottom Angles to the bottom of the Posts as shown. Use 1/2” Sheet
11In the locations marked “Location A” (see the previous page), attach Angle Support Bars to the top of the Post and Deck as illustrated in Close-up #
127Before continuing, make sure that all the Posts are perfectly straight and tighten all screws and nuts securely. You may now remove the saw
138a) Assemble and mount the “Ground to Deck” Ladder to the deck using instructions packed inside it’s carton.b) Assemble and mount In-Pool Ladder
14GENERAL ASSEMBLY ILLUSTRATIONUse the General Assembly Illustration below for reference as you assemble the Fensurround.END POST ORCORNER POSTSTANDAR
Take the Verticals and attach two Fence Post Brackets to each Vertical using the 1/4 x 20 x 3/4” Screws and Washers and Hex Nuts provided as shown. Yo
16Use the illustrations below for reference during attaching the sections of Fence to the Fence Posts as described on the next page.12
17Using the illustration for your size deck on the previous page, assemble the Fence Postions. Note carefully the location for the different sizes.
WARNING LEDGE PLACEMENTENTRY POINTVIEW FROM INSIDE THE DECKLATCHGATEPOSTSELF CLOSING HINGEGATELATCH BAR18Using the Latch, Latch Bar and Hinges as temp
GENERAL Take time to follow the instructions and do things right the fi rst time. Read all instructions prior to starting. Before you start, check t
3Clear out and level the ground in the location where your deck is to be installed. Use the Assembly Drawings below for reference while assembling yo
42IMPORTANT: ONLY HAND TIGHTEN SCREWS AT THIS TIMEElevate your two outside deck sections using either patio blocks or saw horses. Attach the Posts re
5Finally, attach another Long Square Post for the Ladder on either side of your deck in the location illustrated for your deck on the prior page. Cho
3IMPORTANT: ONLY HAND TIGHTEN SCREWS AT THIS TIME6Position the Bottom Support Channels (long “L” shaped pieces) at the bottoms of the Posts according
74aIMPORTANT: ONLY HAND TIGHTEN SCREWS AT THIS TIMEWhere the Posts and the Bottom Support Channels join, attach Angle Support Bars. The illustrations
84bIMPORTANT: ONLY HAND TIGHTEN SCREWS AT THIS TIMEWhere the Posts fasten to the deck, attach Angle Support Bars. The illustrations below indicate wh
SMALLANGLE SUPPORT BARDECKCLOSE UP #13LARGEANGLE SUPPORT BARCLOSE UP #12DECK5IMPORTANT: ONLY HAND TIGHTEN SCREWS AT THIS TIMEFor the 15’ and 18’ Decks
Commentaires sur ces manuels